Easy-in easy-out Special event

The Deflex traffic calming device is a versatile road delineator with many uses: mobile deployment, permanent installation, seasonal use, etc. On this page we provided information and visual assistance to help with the easy installation of the delineator and channelizer.

You’ll find illustrated and video explanation for each installation option. Below is a chart listing suggested spacing for each situation and use of the Deflex road delineator.

EASY-IN EASY-OUT SPECIAL EVENTS

22 inch sleeve anchor for easy delineator installation

22in Sleeve anchor

For asphalt installation.

3395$ per pack of 1

Shipping & applicable taxes not included.
Quantity

Installation steps

Concrete installation : 8 inch sleeve anchor

Suggested tools:
Diamond core drill, tape, level, cement grout, mallet, 9/16’’ (15mm) key.

  1. With the diamond core drill make a hole of 4.5’’ in diameter and 8’’ deep.
  2. Apply tape under the anchor sleeve and insert it into the hole. Make sure the anchor sleeve is vertically level.
  3. Very important that the sleeve is placed 3/8” beneath the surface of the concrete.
  4. Fill the hole around the sleeve anchor with cement grout.
  5. Wait 24 hours for the cement to dry.
  6. With a 9/16’’ (15mm) key, screw the Deflex delineator onto the adapter plate. Insert into hole.

Asphalt installation : 22 inch sleeve anchor

Suggested tools:
Diamond core drill, jackhammer, pointless bit, jackhammer adapter for anchor sleeve, level, cement grout without withdrawal, mallet, 9/16’’ (15mm) key.

  1. With the diamond core drill make a hole of 4.5’’ in diameter and 8’’ deep.
  2. Insert the sleeve anchor using a jackhammer with a pointless bit. Make sure the sleeve anchor is vertically level.
  3. Very important that the sleeve anchor is placed 3/8” beneath the surface of the asphalt.
  4. Fill the hole around the sleeve anchor with cement grout.
  5. Wait 24 hours for the cement to dry.
  6. With a 9/16’’ (15mm) key, screw the Deflex delineator onto the adapter plate.

Soft ground installation : 36 inch sleeve anchor

Suggested tools:
Jackhammer, pointless bit, anchor hammer adaptor, level, cement grout without withdrawal, mallet, 9/16’’ (15mm) key.

  1. Insert the sleeve anchor into the ground with the jackhammer equipped with a pointless bit and the anchor hammer adaptor. Make sure the sleeve anchor is vertically level.
  2. Very important that the sleeve is placed 3/8” beneath the surface of the ground.
  3. Insert the adaptor into the sleeve with a mallet.
  4. With a 9/16’’ (15mm) key, screw the Deflex delineator onto the adapter plate.

Do not attempt to use concrete screws for asphalt installation.

For maximum performance and durability hire an experienced road worker for installation.

SUGGESTED SPACING CHART

Suggested ZoneGuard corridor and critical zone